ATMEGA169P-16MCHR【PDF 213/274 页】MCU AVR 16KB FLASH 16MHZ 64-VQFN

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录3753

209页 210页 211页 212页 [213页]214页 215页 216页 217页

8018P–AVR–08/10

ATmega169P

9.8

Minimizing Power Consumption

There are several issues to consider when trying to minimize the power consumption in an AVR

controlled system. In general, sleep modes should be used as much as possible, and the sleep

mode should be selected so that as few as possible of the device’s functions are operating. All

functions not needed should be disabled. In particular, the following modules may need special

consideration when trying to achieve the lowest possible power consumption.

9.8.1

Analog to Digital Converter

If enabled, the ADC will be enabled in all sleep modes. To save power, the ADC should be dis-

abled before entering any sleep mode. When the ADC is turned off and on again, the next

conversion will be an extended conversion. Refer to ”ADC - Analog to Digital Converter” on page

216 for details on ADC operation.

9.8.2

Analog Comparator

When entering Idle mode, the Analog Comparator should be disabled if not used. When entering

ADC Noise Reduction mode, the Analog Comparator should be disabled. In other sleep modes,

the Analog Comparator is automatically disabled. However, if the Analog Comparator is set up

to use the Internal Voltage Reference as input, the Analog Comparator should be disabled in all

sleep modes. Otherwise, the Internal Voltage Reference will be enabled, independent of sleep

mode. Refer to ”AC - Analog Comparator” on page 212 for details on how to configure the Ana-

log Comparator.

9.8.3

Brown-out Detector

If the Brown-out Detector is not needed by the application, this module should be turned off. If

the Brown-out Detector is enabled by the BODLEVEL Fuses, it will be enabled in all sleep

modes, and hence, always consume power. In the deeper sleep modes, this will contribute sig-

nificantly to the total current consumption. Refer to ”Brown-out Detection” on page 50 for details

on how to configure the Brown-out Detector.

9.8.4

Internal Voltage Reference

The Internal Voltage Reference will be enabled when needed by the Brown-out Detection, the

Analog Comparator or the ADC. If these modules are disabled as described in the sections

above, the internal voltage reference will be disabled and it will not be consuming power. When

turned on again, the user must allow the reference to start up before the output is used. If the

reference is kept on in sleep mode, the output can be used immediately. Refer to ”Internal Volt-

age Reference” on page 51 for details on the start-up time.

9.8.5

Watchdog Timer

If the Watchdog Timer is not needed in the application, the module should be turned off. If the

Watchdog Timer is enabled, it will be enabled in all sleep modes, and hence, always consume

power. In the deeper sleep modes, this will contribute significantly to the total current consump-

tion. Refer to ”Watchdog Timer” on page 51 for details on how to configure the Watchdog Timer.

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式